OWNER’S INSTRUCTIONS
MANUAL DE INSTRUCCIONES
MANUEL D’UTILISATION
Heat pump
Cooling only
AVMCC052CA0
AVMCC072CA0
AVMCC105CA0
AVMCC052EA(B)0
AVMCC070EA(B)0
AVMCC105EA(B)0
AVMCH052CA0
AVMCH072CA0
AVMCH105CA0
AVMCH052EA(B)0
AVMCH070EA(B)0
AVMCH105EA(B)0
System Air Conditioner
Aire acondicionado sistemático
Climatiseur numérique multifonctionnel
E S F A DB98-06190A(1)
Contents
◆
◆
◆
PREPARING YOUR AIR CONDITIONER
◆◆◆Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
◆◆◆View of the Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
◆◆◆Wireless Remote Controller-Buttons and Display . . . . . . . . . . . 6
◆◆◆Wired Remote Controller-Buttons and Display . . . . . . . . . . . . . 7
◆◆◆Centralized Controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
RECOMMENDATIONS FOR USE
◆◆◆Operating Recommendations . . . . . . . . . . . . . . . . . . . . . . . . . . 9
◆◆◆Temperature and Humidity Ranges . . . . . . . . . . . . . . . . . . . . 10
◆◆◆Cleaning Your Air Conditioner . . . . . . . . . . . . . . . . . . . . . . . . . 11
◆◆◆Bio-Pure Filter Installation (Optional) . . . . . . . . . . . . . . . . . . . . 12
◆◆◆Solving Common Problems . . . . . . . . . . . . . . . . . . . . . . . . . . 13
TECHNICAL SPECIFICATIONS
E-3
View of the Unit
The figures are shown in this instruction may differ from yours depending on the model.
Indoor Unit
Air flow blades(outlet)
Air inlet
Air filter(under the grille)
Timer indicator
On/Off button
On/Off indicator
Remote control
sensor
Fan indicator
Filter Sign
indicator
Removing frost
indicator
(Except Cooling
Only Models)
E-4
Outdoor Unit TYPE A
Air outlet
Connection valve
Outdoor Unit TYPE B
Air outlet
Connection valve
Air outlet
Outdoor Unit TYPE C
Outdoor Unit TYPE D
Outdoor Unit TYPE E
Connection valve
Air outlet
Connection valve
Air outlet
Connection valve
If the heat exchanger in the outdoor unit gets dusty, cooling efficiency may fall. So clean the heat exchanger with water
when it becomes dirty. However, be careful when you wash the surface of the heat exchanger because it is very sharp.
Note
E-5
Wireless Remote Controller-Buttons and Display
The wireless remote controller is an optional accessory.
To use the wireless remote controller, refer to an appropriate manual.
Mode selection button
Operating mode
Temperature adjustment
buttons
Temperature setting
Filter Reset button
Fan speed
Fan speed adjustment
button
Air flow direction
Swing button
On Timer setting
On Timer button
Off Timer setting
Off Timer button
Battery discharge indicator
On/Off & Timer
Set/Cancel button
Note
- After cleaning the air filter, press the filter reset button.
- The heating mode( ) is not selected in cooling only models.
E-6
Wired Remote Controller-Buttons and Display
The wired remote controller is an optional accessory and it is installed on the wall.
To use the wired remote controller, refer to an appropriate manual.
Operating mode
Removing frost indicator
(Except Cooling Only Models)
Centralized controller indicator
(In case of installing the Centralized controller)
Communication error indicator
Temperature setting
Fan speed
On Timer setting
Off Timer setting
Air flow direction
Test indicator
Filter Sign indicator
On/Off & Timer
Set/Cancel button
Temperature adjustment
buttons
On/Off indicator
On Timer button
Fan speed adjustment
button
Off Timer button
Swing button
Test button
Filter Reset button
Mode selection button
Note
- Test button is for your installation specialist. You must NOT press it.
- After cleaning the air filter, press the filter reset button. Then the wired remote
controller will display the FILTER SIGN indicator when the time to clean the air filter;
refer to page 11.
- The heating mode( ) is not selected in cooling only models.
E-7
Centralized Controller
The centralized controller is an optional accessory and it is installed on the wall.
To use the centralized controller, refer to an appropriate manual.
Operating lamp
All On button
All Off button
On/Off indicators
On/Off buttons
Index
Note
Operating lamp comes on when at least one air conditioner connected to the
centralized controller is operating.
E-8
Operating Recommendations
Here are a few recommendations that you should follow when operating
your air conditioner.
Topic
Recommendation
Heating
The heat pump function of the air conditioner absorbs heat
performances from outside air and brings it indoors. As the temperature of the
outside air drops, the heating performance of air conditioner will
decrease. If you find that the room is not warm enough, using
an additional heating appliance is recommended.
Frost
When outside temperature is low but humidity is high,
frost may form on the outdoor unit at HEAT mode.
If this happens:
◆◆The heating operation stops.
◆◆The defrost mode will be triggered automatically for about ten
minutes.
No intervention is required ; after about ten minutes, the air
conditioner operates again normally.
High indoor
and outdoor
If both indoor and outdoor temperatures are high and the air
conditioner is running at HEAT mode, the outdoor unit’s fan
temperatures and compressor may stop at times.
This is normal ; simply wait until the air conditioner switches
on again.
Power failure
If a power failure occurs while the air conditioner is operating,
the unit will be switched off. When the power returns, the air
conditioner starts up again automatically.
E-9
Temperature and Humidity Ranges
The following table indicates the temperature and humidity ranges,
within which the air conditioner can be used.
If the air conditioner is used at...
Then...
High temperature
The automatic protection feature may be
triggered and the air conditioner stopped.
Low temperature
A water leakage or some other
malfunction may happen if the heat
exchanger freezes.
High humidity levels
Water may condense on and drip from
the surface of the indoor unit if it is used
for a long periods.
Mode
Heating
Cooling
Drying
Outdoor Temperature
-20°C to 24°C approx.
- 5°C to 43°C approx.
-5°C to 43°C approx.
Indoor Temperature
27°C or less
Indoor Humidity
-
21°C to 32°C approx.
18°C to 32°C approx.
80% or less
-
◆◆ If the heating operation is used at below 0°C(outdoor temperature) then,
it does not heat at its full capacity.
If the cooling operation is used at over 33°C(indoor temperature) then,
it does not cool at its full capacity.
E-10
Cleaning Your Air Conditioner
To get the best possible use out of your air conditioner, you must clean
it regularly to remove the dust that accumulates on the air filter.
Before cleaning your air conditioner, ensure that you have
switched off the electric circuit breaker used for the unit.
IMPORTANT
Open the front grille by pushing the tabs on the grille.
1
You must give attention when disassembling the front grille
and must check the safety clips have been installed.
If you do not check them, the front grille will drop suddenly
and you will be hurt.
IMPORTANT
Remove the front grille.
2
2-1 Remove the safety clips.
2-2 Open the front grille about 45° and pull it forward.
Pull out the air filter.
3
4
Remove all dust on air filter with a vacuum cleaner or a brush. In case of
serious dust accumulation, put the air filter in warm detergent water and
shake it vertically.
Safety Clip
Note
When you have installed the Bio-Pure filter, do not allow any
liquids to contact the filter. It may lose its properties.
Dry the air filter.
5
6
7
8
When you have finished, insert the filter into the front grille.
Clean the unit with a vacuum cleaner or a brush once a month.
Reinstall the front grille and the safety clips.
Note
You can use all 4 points of the indoor unit for installing the front
grille and the safety clips depending on your requirement.
Note
After cleaning the air conditioner, press the Filter Reset button.
Wired Remote Controller
Wireless Remote Controller
E-11
Bio-Pure Filter Installation (Optional)
The air conditioner can be fitted with a Bio-Pure filter to remove minute dust
particles. The service life of the filter is approximately three months depending
on the time during which the air conditioner is used.
Remove the vinyl packing from the filter.
1
Note
Do not remove the packing from a bio-pure filter until you wish
to use the filter, as it will lose its properties.
Open the front grille by pulling the tabs on the grille.
2
3
Remove the front grille.
3-1 Remove the safety clips.
3-2 Open the front grille about 45° and pull it forward.
Pull out the air filter.
4
Locate the bio-pure filter on the center of air filter.
Secure the bio-pure filter with four screws.
5
6
7
Reinstall the air filter, the front grille and the safety clips.
E-12
Solving Common Problems
Before contacting the after-sales service, perform the following simple checks.
They may save your time and expense of an unnecessary call.
Problem
Explanation/Solution
The air conditioner does not ◆ Check that the breaker used for the air conditioner is switched on.
operate at all
Wired Remote Controller
The air conditioner does not
operate with the remote
controller
◆
is displayed on the wired remote controller. In this case,
turn the air conditioner off and contact your dealer.
Wired Remote Controller
When turning on/off the
air conditioner, it is not
◆ In case of using the wired remote controller for a group, the air
conditioners connected to the remote controller are turned on/off in
order. Thus, it takes some time(up to 32 seconds).
turned on/off immediately.
Wireless Remote Controller
The air conditioner does not ◆ Check that there are no obstacles between you and the remote
operate with the remote
controller
control sensor.
◆ Check the wireless remote controller batteries.
◆ Check that you are close enough to the remote control sensor.
(seven metres/yards or less).
Wireless Remote Controller
No beep is heard when you ◆ Check that you are pointing the remote controller at the remote
press
(ON/OFF) on the
control sensor on the indoor unit.
remote controller
◆ Replace the remote controller batteries if necessary.
◆ If there is a strong light around the air conditioner, a
three-wavelength light, a neon sign, etc., for example,
the air conditioner may not be operated with a remote controller.
If this happens, use the remote controller close by the remote
control sensor.
The air conditioner does
not cool or heat
◆ Check that the correct operating mode has been selected.
◆ The room temperature may be too low or too high.
◆ Dust may be blocking the air filter guard; refer to page 11
for cleaning instructions.
◆ Check that there is no obstacle in front of the outdoor unit.
When heating, the required ◆ Check that the required temperature has been set correctly.
room temperature is never
reached and the air
◆ Increase the fan speed.
conditioner frequently stops
E-13
Technical Specifications
Model
Power Supply
AVMCH052CA0
AVMCH072CA0
AVMCH105CA0
1Ø, 208-230V~, 60Hz
AVMCC052CA0
AVMCC072CA0
AVMCC105CA0
AVMCH052EA(B)0
AVMCH070EA(B)0
AVMCH105EA(B)0
1Ø, 220-240V~, 50Hz
AVMCC052EA(B)0
AVMCC070EA(B)0
AVMCC105EA(B)0
E-14
Memo
E-15
THIS AIR CONDITIONER IS MANUFACTURED BY:
ESTE AIRE ACONDICIONADO HA SIDO FABRICADO POR:
CE CLIMATISEUR EST FABRIQUE PAR:
ELECTRONICS
Printed in Korea
|